Airbag Light

Eddie Owner/Technician Austin, Texas Posted   Latest   Edited  
Discussion
Safety
2016 Nissan Frontier PRO-4X 4.0L (VQ40DE) 5-spd (RE5R05A) — 1N6AD0EV2GN773737
No Code
Airbag Blinks

hello guys 

need some tips to put me in right direction got this Nissan with airbag light from used car lot scan the system find no fault code but airbag light blinks try all my scan tools i have same result want to know if anybody had experience with bad air bag module causing that ?

le me know please 

thanks in advance 

0
Leon Owner/Technician
Telford, United Kingdom
Leon Default
 

Is the module locked?

0
Default Ð Bounty Awarded
Steven Technician
Huntington Beach, California
Steven Default
 

Are there any codes in the ABS?

0
Default Ð Bounty Awarded
Benjamin Diagnostician
Murfreesboro, Tennessee
Benjamin Default
 

You need to check for codes in the occupant classification system. If there are none you need to re-zero/calibrate the system.

0
Default Ð Bounty Awarded
Benjamin Diagnostician
Murfreesboro, Tennessee
Benjamin Default
 

Many times I have had to replace the OCS module, and sometimes the seat rail sensors if the system will not calibrate. I always start by replacing the module and leave it open ended that the sensors may need replacing as well. As far as aftermarket tooling goes I have had better luck with Snap On than Autel when it comes to zeroing the OCS on these.

0
Default Ð Bounty Awarded
Eddie Owner/Technician
Austin, Texas
Eddie Default
 

i did replace complete seat since i could not find the module in out local dealer in stock and same issue ill try zero the OCS again thanks

0
Default Ð Bounty Awarded
Allan Owner
Sterling, Virginia
Allan Default
 

There are recalls on most Nissans of that era for that or similar issues. Its almost always the seat weight sensors. Probably one on each corner, Nissan Diagnostics for that is about as poor as it gets. Also when you call the dealer about a recall it will apply to literally every vehicle possible except the one you have

+1
Default Ð Bounty Awarded
Dean Owner
Albany, New York
Dean Default
 

Gateway in module is locked. Professional repair is to replace and program the replacement module.

0
Default Ð Bounty Awarded
Todd Technical Support Specialist
Roseville, Minnesota
Todd Default
 

Is it in "Self Diagnosis Mode"? DIAGNOSTIC PROCEDURE 6 Inspect SRS Malfunction Using ”AIR BAG” Warning Lamp—Diagnosis Mode NOTE: SRS will not enter Diagnosis mode if no malfunction is detected in User mode. 1. Turn ignition switch ON. 2. After “AIR BAG” warning lamp lights for 7 seconds, turn ignition switch OFF within 1 second. 3. Wait more than 3 seconds. 4. Repeat steps 1 to 3 two more…

0
Default Ð Bounty Awarded