Audi sunroof adaptation/coding
Scanned vehicle for codes comes up: 01512 - Control Module for Sliding Roof 005 - No or Incorrect Basic Setting / Adaptation. This shop changed motor and switch, same problem.
I attempted to perform adaptation, coding and basic setting with my autel 908s, all complete successfully. The sunroof open/closes/tilts through this process but I still cannot control via buttons on the ceiling.
any suggestions?
See if you can read the value blocks for the switch to see if the position commands are being recognized, also you could try a capacitive discharge by disconnecting the battery cables and touching them to each other to reset the modules
If my memory is correct. Switch is 4 wire. Turn headlights on and see if switch illumination lights come on. If it does not check to see if ground is present. If ground is missing, needs roof motor. Motor is ground provider for switch. You can provide a ground and all should operate. I also forgot to mention. Operate drivers door with key blade and hold it in unlock position to see if roof…
You need either a Rosstech or ODIS to complete the basic settings successfully