2012 F150 rear camera image reversed
2012 F150 rear camera inop, new Ford camera installed and it now works however the image is reversed. Service information doesn't say anything about programming or configuring for a 2012, 2013 does say that it needs to be configured. Used the IDS to try to configure. It gives me the option but the test is aborted after a few seconds. Unsure if it aborts because something is wrong or if it aborts because that test is not supported on 2012 F150.
ETA-BCM is setting a B115E:49 Internal camera failure with the new camera installed. It had a C1001 with the old camera. I will update again Monday when I get back to this truck.
If the camera is malfunctioning there should be a code. RVC configuration or Lin new module initialization would be the function. Typically when needed it triggers a B115E:55. Make sure the application is correct as well, sometimes the wrong camera can be installed and cause issues.
It's the camera itself. I had that issue with a lincoln rear view camera, turns out the camera was physically upside-down. Exchanged it, ask was well.
This happens with aftermarket .seen it before. It will need rvc config afterwards
BCM is setting a B115E:49 Internal camera failure with the new camera installed. It had a C1001 with the old camera. I will update again Monday when I get back to this truck.
B115E:49 Camera Module: Internal Electronic Failure : CLEAR the DTCs. REPEAT the self-test. If DTC B115E:49 is retrieved again, INSTALL a new rear video camera.
Something is wrong with the new camera. Get a new one. Make sure it's the correct part #
While I do not have an answer to your situation, this problem is also being discussed in Forscan's forum. Maybe you'll gleam some insight there also. forscan.org/forum/viewtopi…