Engine Table Lift
Looking to buy an engine table lift. The model from AGA Looks amazing. 4.5k makes me pause. Any input?
We have the AGA table lift and highly recommend it. Well built and very versatile. Considering the price of other tables I have seen, I think its a fair price.
Thanks. Have not seen anything close so far. Just thought I would ask the collective genius that is Diagnostic Network their thoughts...
I stumbled at the price also, but based on the recommendations of others, we bought it. It has proven to be an excellent investment. Well designed, well built and well supported. If you buy it, ask for the kit to slow the descent rate. It may now be standard, but it was a free upgrade when we bought ours.
Thank you. Ordering one before the month is out...
Through my networking in the Porsche community, the shops that bought them absolutely loved them until they lowering valve would not stop lowering, they were in the middle of dropping a Porsche engine and it just kept lowering as if you were holding it to lower, one of the techs had to keep pumping it to stop it from lowering while another tech figured a way to stop it. This happened to a few…
Hey Jeff, We had the same problem once, but it essentially was our fault. The unit has two lowering levers: one foot and one hand, and they operate the same valve. The hand lever is cable operated (think caliper brakes on your first real bicycle) and we inadvertently pulled the sheath out of the collar, which kept the inner cable taught, thus lowering. We since sorted out the cable adjustment…
Hi Paul, We have this one and have been quite pleased with it: globalindustrial.ca/p/material-han…
Scott, We also have this table and use it for a lot more then just powertrain jobs.