Key relearn issue After ECM replacement
What repair are you unable to perform?
IMMO - Immobilizer Relearn
What information are you having trouble obtaining?
Help trying to perform IMMO - Immobilizer Relearn after ECM replacement I am getting this error message:
Body Control Module
Parameter ID not supported
Please reprogram ECU with correct SPS software calibration
Connector HS CAN Bus
Controller Body Control Module
Error Number 2112
What steps have you taken to obtain the information you need?
Contacted AcDelco TDS support line three times
Contacted AcDelco Training Instructors
Contacted Auto Aide
(Optional) Any other comments or concerns?
I have replaced:
- ECM (Missfire caused by driver i ECM is open circuit)
- BCM (Recommended by AcDelco TDS support)
- New ignition key (Recommended by AcDelco TDS support)
- New Immobilizer (Recommended by AcDelco TDS support)
I Have Attached a list of DTCs, A scope shot of the immobilizer sending a signal when key is turned to run position and a screen shot of error message when I try and do any learn function in SPS IMMO list