I can't register keys in used Nissan ECM
Hello everyone! I have a 2016 Nissan Rogue that was involved in a crash and the ECM crashed, I bought a used one from a salvage yard exactly the same model, year, engine size now everything is fine I can register two smart keys, I can lock and unlock all the doors, instrumentation everything works only now I have a DTC in the ECM P161F - Immobilizer and one in the BCM B2192 - ID Discord BCM-ECM the car crank but not start., by the manual Nissan says that I have to replace the ECM (Blank ECM) and costs around $ 1300.00. Does anyone know where I could virginize, unlock the used ECM that I already have or some suggestion or if I really have to buy it new from Nissan, I appreciate all the help you can give me.
By looking at thee price it most be either Korean or Japanese made. and unfortunately you cant use a used ecm on those Nissan, has to be brand new. That ecm is OTP (One time programming).
Hi it is not possible to reprogram, you must install a new BCM. Last year I spent more than 15 hours on a 2016 Rogue and I tried everything, I try to reprogram used key, jobber key, original key, used BCM, Cloning BCM, remove immo. Impossible to do anything. I even send the vehicle to another workshop doubting my procedure and the same result. Searching alldata, there is a technical bulletin…
Hi Ghislain, A few years ago this would have been true.. but these vehicles can be programmed with new or original keys. Attached is the TSB. NTB15-052
Hi Ghislain, the only part I am replacing is the ECM, the BCM is the original and one new smart key, I also have to replace the BCM as you say thank you ?.
Too many factors to give you a direction at this point.. - need the Vin # - need the ECM part number.. Starts with 23710 ( not the numbers on outside of case ) . Read through a scan tool. Even though the ECM was replaced from the same vehicle the software installed in that ECM may not match your vehicle. There are several different options within a model. Not to mention Nissan uses 2…
Hello Steven !, the VIN #: KNMAT2MT5GP652044 of my Rogue and the one of the donor car is KNMAT2MT9GP679733 and the ECU PART # 23710-5HJ0E, CVN ECM:0BED049E, SUPPLIER #:A0604, MANUFACTURE:80 and I use Autel MS919 with Nissan Pin Wizard TDB005 from The Diagnostic Box (Pin Conversion 20 Digit Code), when the car arrived with me did not work anything doors, instrumentation after registering two…
The original Vin # the ECM part number is 23710-5HJ0C the Donor is 23710-5HJ0E .. Both these part numbers even though different when fully updated would match to 23710-5HJ4C, so the ECM's are compatible which is a good thing. Which means the keys should program. There is a two step process when programming these keys.. the intelligent key and then the remote gets programmed. When you are…
I have the Consult 3 Plus but I do not have the security card and I tried to change the VIN # with it but I did not succeed, the security light I do not remember well what you tell me but I will try again to pay attention to that what are you saying and thanks for taking the time to help me.
The security light is on the instrument cluster next to the #8 on the RPM gauge.