Sps2
Anyone having issues with SPS2 today? Yesterday? Its working really slow and not properly booting up. I have not had problems since release until yesterday! Just making sure its not on my end!
Also having issues! Getting a server error and states not authorized etc.
I used it this morning but it's now giving various errors.
I did three vehicles today, with no issues in Florida. All around 10:00-2:30 cst. Time. maybe went after that? it did an automatic update before one sps2 job.
I am having issues, keeps giving error message.
There was an update yesterday and my helper had a hell of a time programming a tcm. Almost 2 hours rebooting , uninstalling , re installing etc I use it 3 times around same time without a single issue, I have a better laptop than him so maybe update made it harder for older laptops
I’m at a dealer and yes it’s down. should be ok in a little bit
Thank you all!! Hopefully its working when I go back to my client tomorrow!
Was definitely giving me a hard time today. Typically works quite well for me but today I gave up and said I would come back another day.
Tomorrow will be the 3rd try! Wish ACDelco cared enough to have the ability to display a message on the website! It sucks that we have to post messages like this because we don’t know if its their server or our laptops!
Anyone still having problems this morning 10/27? I am getting to the tlc admin console through acdelco tds but TLC won't launch
SPS2 performed an update this past Friday … as I was about to program a TCM in a 6L90 transmission we just installed. The re-flash failed and retried 2 times only to give Error codes E4491 and E4423. The programming was unsuccessful after 3 more attempts and a computer reboot. The error codes may have to do with the vehicle, but I have not been able to perform any reprogramming…
Was the module new or used? What year vehicle? Check and see if all your signals are at the module. Also what windows are you using? With sps2 things are simpler yet more complicated. Conundrum!
We purchased this unit through ETE. They say that the module is new. The vehicle is a 2011 Chevy Express 3500 with a 6.0L engine. We are using Windows 10 professional on a 64bit laptop. We've checked wiring and all seems to be well. However, this van does have a fancy aftermarket radio. I think that's why we're getting the error codes (because of the radio), but SPS2 is definitely not working…