No communication with the TCM. Car is in limp mode
Question
Updated
Driveability
Network Communications
2006 Chrysler 300 C 5.7L (H) 5-spd (NAG1)
P0605 — Internal Control Module Read Only Memory (ROM), Error
U0101 — Lost Communication with TCM
Car Will Not Accelerate Over 40 Mph
Good evening I'm having a issue finding the problem on this 2006 Chrysler 300. I check the power, ground, the high and low bus communication to the TCM and all checks out fine.
0
Mario
Load test those powers and grounds, all of them. If they are fine, replace tcm
+1
Ð Awarded
Matt
I would disconnect the pcm and see if you have comm with tcm. The P0605 is a pcm failure code for the most part.
0
Ð Awarded
Frank
As Mario stated, make sure your power and ground can carry current. I've chimed in because I encountered the identical symptoms and codes no longer than 2 months ago...300srt with nag1. Used tcm followed by programming was the fix.
0
Ð Awarded