Ford Escape 2020 2.0 Titanium start problem after FDRS PCM ABS module software update
We have updated the ABS module software after that we did the PCM configuration using FDRS. Everything seemed worked ok, but after the engine starts only in the service mode and after switching transmission from P to D, the engine stops. Additionally, there is a complete lack of power steering but no DTC codes present. What worries me is that during programming, the external power supply had a power cut and programming was completed only on battery power. There were no error messages(incorrect programming, records, etc.) from FDRS after.
When I connect the car to Forscan after trying to shift from P to R, i can read “P1595 - Forced Engine Shutdown - Remote Start System Fault, Transmission Range Not In Park Position”. it's strange because the key is inside the car.(this code is not present using FDRS)
Right now I do not know what to next to bring car back to normal functionality. Do more updates ?, modules configuration, check PCM module if it is not damaged?
Attached history what i did using FDRS.
ps. sorry for my English.
Do you have any Body control codes ? Also try disabling remote start in IPC settings.
Nothing important , before this “bad action” I had only: ===BdyCM DTC B14E7:08-0A=== Code: B14E7 - Right Front Enhanced Exterior Lighting System ===BdyCM DTC B14E5:01-0A=== Code: B14E5 - Left Front Enhanced Exterior Lighting System codes are active because we had replaced headlights to full adaptive led (and I need to add HCM this Escape is not equipped with) “Also try disabling remote…
There is no information about changes to the IPC in the standard manual, thank you for the tip
Hi Lonny, I may have overlooked in the info, but can you please provide me w/ the VIN?
I don't have the VIN. The Gentleman from Poland posted this thread and did not share that information.
Last week I had a problem with a 2020 explorer, after update of the parking aid module nothing was working . Disconnected battery for a few minutes and everything went back to normal. Did you try that already?
Yes I have tried, battery was disconnected few hours. Did not help;(
First photo- modules which are not with last firmware( all the rest are up to date), second shows that some of modules are not active, 3rd pic shows log after I wanted to perform Relearn Vehicle Data(the procedure failed, the system did not see the engine running) To add something: car was working almost perfect before our first FDRS connection on 11.19.21 (we had only turbocharger vaste gate…
Are you saying that you had engine running when you tried relearn?
Attempt to reprogram and/or update Key On ,engine off.
PMI both, When it says to install new module , don't and hit next.
Hello, thank you for help. I have done BCM and PCM PMI, I hit “NO” on question “Is the original module installed” Unfortunately problems are still the same: 1.Engine stops after I change transmission form P to R or D 2. Power steering is not working
You can call me at … and I will try to walk you through it.